fuse box RENAULT TWINGO RS 2009 2.G Electrical Equipment - Rev Counter Instrument Workshop Manual

83E-15
MR-413-X44-83E000$756_eng.mif
V2
83E
REV COUNTER INSTRUMENT
Fault finding - Interpretation of statuses
ET002
SIDE LIGHTS SWITCH
STATUS
DEFINITION–ACTIVE: This status indicates that the side light control is active.
–INACTIVE: This status indicates that the side light control is inactive.
NOTES–Ignition on.
–Side lights on.
If the status of the side light control remains at status INACTIVE, apply the following fault finding procedure.
Check fuse F43 (10A) of the passenger compartment fuse box, component code 1016.
Check that the connection and condition of the rev counter connector are correct (see Wiring Diagram Technical
Note, Twingo II, Component code 995).
If there is a repair method (see Technical Note 6015A, Electrical wiring repair, Wiring: Precautions for repair)
repair the connector, otherwise replace the wiring.
Check the + 12 V feed on connection LPG of component 995.
If there is a repair method (see Technical Note 6015A, Repairing electrical wiring, Wiring: Precautions for
repair) repair the wiring, otherwise replace it.
Check the continuity and insulation of:
Connection LPG between the passenger compartment fuse box, component code 1016 and the rev
counter, component code 995.
Connection MAM of the rev counter, component code 995.
Connection MAN of the rev counter, component code 995.
If there is a repair method (see Technical Note 6015A, Repairing electrical wiring, Wiring: Precautions for
repair) repair the wiring, otherwise replace it.
If the fault is still present, contact the techline.
CPT_V04_ET002

Vdiag No.: 04
MR-413-X44-83E000$756_eng.mif

83E-17
MR-413-X44-83E000$924_eng.mif
V2
83E
REV COUNTER INSTRUMENT
Fault finding - Fault Finding Chart
ALP1 No dialogue with the computer
NOTESNone
Test the diagnostic tool on another vehicle which is in perfect working order.
Check that the sensor's green indicator light comes on.
If communication with the second vehicle is impossible, follow the instructions in the CLIP diagnostic tool test
section.
If dialogue with the second vehicle is possible, follow the instructions in the Vehicle check section.
DIAGNOSTIC
TOOL CHECK
Check the cleanliness and condition of the diagnostic socket contacts on the vehicle.
Check the condition of the cable from the diagnostic socket to the sensor, and the
cleanliness and condition of the connections.
Check the sensor connections.
Check the condition of the cable from the sensor to the CLIP tool, and the cleanliness
and condition of the connections.
Check the cleanliness and condition of the CLIP socket.
If the fault is still present, contact Techline.
Check the electrical voltage of the battery.
Check the cleanliness and condition of the battery terminals.
Check the condition of the battery earth cable and ensure that there is a good
electrical connection with the bodywork.
Check the condition and correct connection of the rev counter connector, component
code 995.
If there is a repair method (see Technical Note 6015A, Electrical wiring repair,
Wiring: Precautions for repair) repair the connector, otherwise replace the wiring.
Check rev counter supply fuse F18 (15 A) on the passenger compartment fuse box
component code 1016, and the status and cleanliness of the contacts.
Check the rev counter after ignition feed supply fuse F2 (15A) on the passenger
compartment fuse box, component code 1016, and the condition and cleanliness
of the contacts.
VEHICLE CHECK
CPT_V04_ALP01

Vdiag No.: 04
MR-413-X44-83E000$924_eng.mif